ATEN Global Service Site


Subject :
	PN0108 Factory default settings recovery

Description :
	How do I recover the PN0108 switch by resetting it back to the factory default settings?

Solution :
	There is a reset switch on the front panel of the PN0108. Press and hold the button for more than three seconds, and it will reset the PN0108 back to the factory default settings. If you forget the password to the PN0108, do the following: 1.Power off the PN0108 and remove the cover. 2.Use a jumper cap to short the jumper labeled J4. 3.Power on the switch. 4.Wait 5 seconds, then power off the switch. 5.Remove the jumper cap from J4. 6.Close the housing and power on the PN0108. Now you can use the factory default Username and Password to log in.

Related FAQ :
	3D 디스플레이
	我可以同时采用级联和多显示安装?


Was this information helpful?		Y N
Any commend for this FAQ?

Thank you for your valueable comment!!!!

If you need more assistance, please click the button on the right (Ask Question) and one of our experts will help you